CLVTH16245AQDGGRQ1 ,3.3-V ABT 16-Bit Bus Transceivers With 3-State Outputs SCAS772C − JUNE 2004 − REVISED JANUA ..
CLVTH16543MDLREP ,Enhanced Product 3.3-V Abt 16-Bit Registered Transceiver With 3-State Outputs 56-SSOP -55 to 125FEATURESDGG OR DL PACKAGE• Controlled Baseline(TOP VIEW)– One Assembly/Test Site, One Fabrication1 ..
CLY10 ,Power Amplifier for Mobile Phones (0.... GaAs FET CLY 10Data Sheet• Power amplifier for mobile phones For frequencies from 400 MHz to 2.5 ..
CLY10 ,Power Amplifier for Mobile Phones (0....Characteristics Symbol Limit Values Unit Test Conditionsmin. typ. max.Drain-source I 1.2 1.6 2.4 A ..
CM04RC , COMMON MODE CHOKE COILS (FOR DC AND SIGNAL LINES) SMD TYPE
CM04RC01T , COMMON MODE CHOKE COILS (FOR DC AND SIGNAL LINES) SMD TYPE
CR12AM , MEDIUM POWER USE NON-INSULATED TYPE, GLASS PASSIVATION TYPE
CR12BM , MEDIUM POWER USE NON-INSULATED TYPE, GLASS PASSIVATION TYPE
CR14-MQP/1GE ,ISO14443-B Reader ICFeatures■ Single 5 V ±500 mV supply voltage■ SO16N package■ Contactless communication16– ISO14443 t ..
CR14-MQP-1GE ,ISO14443-B Reader ICAbsolute maximum ratings . 35Table 9. I²C AC measurement conditions . . . . . 36Table 10. ..
CR14-MQTP/1GE ,ISO14443-B Reader ICCR14ISO14443 type-B contactless coupler chipwith anti-collision and CRC management
CR160 ,Diode Current Reg. 135V 1.76mA 2-Pin TO-206AAS-04234—Rev. D, 02-Jul-013-1CR160 SeriesVishay Siliconix Peak Operating Volta ..
CLVTH16245AQDGGRQ1
3.3-V ABT 16-Bit Bus Transceivers With 3-State Outputs
Operation and Low Static-Power
Dissipation Supports Mixed-Mode Signal Operation
(5-V Input and Output Voltages With
3.3-V VCC) Supports Unregulated Battery Operation
Down To 2.7 V Typical V OLP (Output Ground Bounce)
<0.8 V at VCC = 3.3 V, TA = 25°C Distributed VCC and GND Pins Minimize
High-Speed Switching Noise Flow-Through Architecture Optimizes PCB
Layout Ioff and Power-Up 3-State Support Hot
Insertion Bus Hold on Data Inputs Eliminates the
Need for External Pullup/Pulldown
Resistors Latch-Up Performance Exceeds 500 mA Per
JESD 17
description/ordering informationThe SN74LVTH16245A is a 16-bit (dual-octal) noninverting 3-state transceiver designed for low-voltage (3.3-V)CC operation, but with the capability to provide a TTL interface to a 5-V system environment.
This device can be used as two 8-bit transceivers or one 16-bit transceiver. It allows data transmission from the
A bus to the B bus or from the B bus to the A bus, depending on the logic level at the direction-control (DIR)
input. The output-enable (OE) input can be used to disable the devices so that the buses are isolated.
Active bus-hold circuitry holds unused or undriven inputs at a valid logic state. Use of pullup or pulldown resistors
with bus-hold circuitry is not recommended.
1B2
GND
1B3
1B4CC
1B5
1B6
GND
1B7
1B8
2B1
2B2
GND
2B3
2B4CC
2B5
2B6
GND
2B7
2B8
2DIR
1A2
GND
1A3
1A4CC
1A5
1A6
GND
1A7
1A8
2A1
2A2
GND
2A3
2A4CC
2A5
2A6
GND
2A7
2A8
2OE
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
